Alarm solution 0x2e112007 “The OLT cannot receive expected optical signals from the ONT in four consecutive frames”

Recently noticed that OLT (MA5683T) disables one ONT and reports an alarm “0x2e112007”.

After watching the alarm history:

display alarm history all
display alarm active all
alarm active clear all
display alarm active all

Observed the following:

ALARM 470141 FAULT WARNING 0x2e112007 SERVICE QUALITY 2017-10-19 09:17:50+02:00
ALARM NAME : The distribute fiber is broken or OLT can not receive
expected optical signals from GPON ONT(LOSi)
SRVEFF : SA
PARAMETERS : FrameID: 0, SlotID: 4, PortID: 3, ONT ID: 38, Equipment ID:
I-010G
DESCRIPTION : The OLT cannot receive expected optical signals from the ONT
in four consecutive frames
CAUSE : (1) The fiber is broken
(2) The quality of the optical path is poor
(3) The ONT hardware fails
ADVICE : (1) Check tributary optical fiber connection and backbone
optical fiber orderly, clean the fiber connector and replace
the fiber if necessary
(2) Ensure that the optical attenuation of the optical path is normal
(3) Reset the ONT or replace the ONT
— END

I tried to activate ONT:

interface gpon 0/4
ont activate 3 38
quit

But OLT still turned it off, at different intervals of 1-10 minutes.

Example of viewing the statistics of the number of alarms:

display alarm statistics

Viewing the alarm configuration:

display alarm configuration 0x2e112007

The ONT model was TP-Link GP110 with a signal of -15 for receiving and 2.1-2.7 for sending.
We tried to replace ONT with Alcatel-Lucent I-010G, the signal became -17, and OLT even more often began to turn it off.
Cleaning the connectors and digesting the dividers also did not help.

The problem was in a sagging piece of cable that hung from a very high altitude, after its replacement, the alarm disappeared, and the send signal became stable 2.46.

Leave a comment

Leave a Reply