Connecting SFP-RJ45 Modules to the Cisco 6500

It took a couple of days ago to the Cisco Catalyst 6509-E in which there were modules only with SFP ports to connect a few links with RJ45.

Since RJ45 links are small, it was more economical to use SFP-RJ45 modules, so they were ordered.
I connected them to the ports WS-X6724-SFP, but nothing was displayed in the logs.

Let’s write commands so that Cisco does not disable ports when inserting unsupported modules:

service unsupported-transceiver
no errdisable detect cause sfp-config-mismatch
no errdisable detect cause gbic-invalid

I note that the ports WS-X6724-SFP in my case work only at 1Gb speed, so the link will not naturally rise to 100Mb or 10MB, although the Foxgate SFP-RJ45 modules that we had and support 10/100/1000.

In confirmation of this I checked the commands:

configure t
interface gigabitEthernet 1/1
speed ?

What was the opportunity to specify the speed of the port only in 1000.

See also:
Configure Cisco Catalyst 6509-E

Leave a comment

Leave a Reply

Discover more from IT Blog

Subscribe now to keep reading and get access to the full archive.

Continue reading