How to change MTU on Cisco

I will give an example of increasing MTU on Cisco switches.

Let’s look at the current configuration, the names of the necessary interfaces and go to the configuration mode:

show running-config
configure t

Let’s say that traffic with an MTU of more than 1500 can go between two ports, select the first port and increase the MTU:

interface GigabitEthernet2/24
mtu 9216

Then we increase the MTU on the other port:

interface TenGigabitEthernet3/3
mtu 9216

For example, I indicated the MTU of 9216 bytes, since I had a Cisco 6509E at hand in which you can specify only such an MTU size, to check which size you can specify, run the command:

mtu ?

For example, to test MTU with ping packets, run the command in Linux:

ping -M do -s 8000 192.168.5.5

Don’t forget to increase the MTU on the network interface in Linux:

ifconfig
ifconfig eno1
sudo ifconfig eno1 mtu 9000

See also my article:
Configuring Jumbo Frame on Cisco Nexus 3064

Leave a comment

Leave a Reply

Discover more from IT Blog

Subscribe now to keep reading and get access to the full archive.

Continue reading