To view information about the ONU / ONT, connect to Huawei SmartAX MA5683T via telnet using the putty utility or via the windows command line, for example, by typing the command:
telnet 192.168.0.5
After entering the login and password, go to the gpon interface menu:
enable
config
interface gpon 0/5
Then you can perform a number of commands, I will describe in order.
View information about the ONU (where the first 0 means the GPON port number on the GPON board, and the second ONU number):
display ont info 0 0
Viewing current traffic to the ONU (where the first 0 means the GPON port number on the GPON board, the second ONU number, and the one the ethernet port number on the ONU):
display ont traffic 0 0 1
View ONU optical information:
display ont optical-info 0 0
View ONU version:
display ont version 0 0
View brief statistics of the ONU port ethernet:
display statistics ont-eth 0 0 ont-port 1
ONU capability:
display ont capability 0 0
ONU ports status:
display ont port state 0 0 eth-port all
display ont port state 0 0 eth-port 1
ONU Registration Information:
display ont register-info 0 0
View the number of MAC addresses on the ONU:
display ont mac-count 0 0
You can view MAC addresses on ONUs only through the service-port, in order to find out its number, we will find it in the configuration, for example:
display current-configuration | include 0/5/0 ont 0
When the service-port number is known, look at the MAC addresses:
display mac-address service-port 1433
To exit the gpon interface menu, use the quit command, re-entering the command will exit and disconnect from the device.
The command displays information about the service-port to which the ONUs are connected:
display service-port all
On some firmware versions, you can see the MAC address on the ONU using for example a command (for example, the command does not work on the MA5683T MA5600V800R008C01, but it works on the MA5608T MA5600V800R015C00):
display mac-address port 0/0/0 ont 0
See also my article:
Configuring Huawei SmartAX MA5683T