Расшифровал из прошивки Huawei SmartAX MA5683T несколько OID.
Пример команды проверки MIB и OID из Linux:
snmpwalk -v 2c -c public 192.168.1.10 .1
Далее приведу список OID и кратко опишу их.
Описание GPON ONT:
.1.3.6.1.4.1.2011.6.128.1.1.2.43.1.9
Описание EPON ONT:
.1.3.6.1.4.1.2011.6.128.1.1.2.53.1.9
Имя lineprofile:
.1.3.6.1.4.1.2011.6.128.1.1.2.43.1.7
Имя ont-srvprofile:
.1.3.6.1.4.1.2011.6.128.1.1.2.43.1.8
Оптическая мощность до GPON ONT (ont rx power):
.1.3.6.1.4.1.2011.6.128.1.1.2.51.1.4
Оптическая мощность до EPON ONT:
.1.3.6.1.4.1.2011.6.128.1.1.2.104.1.5
Оптическая мощность до OLT от ONT (olt rx power):
.1.3.6.1.4.1.2011.6.128.1.1.2.51.1.6
ONT in byte:
.1.3.6.1.4.1.2011.6.128.1.1.4.23.1.4
ONT out byte:
.1.3.6.1.4.1.2011.6.128.1.1.4.23.1.3
ONT Mac/Serial:
.1.3.6.1.4.1.2011.6.128.1.1.2.43.1.3
Температура плат:
1.3.6.1.4.1.2011.2.6.7.1.1.2.1.10 (hwMusaBoardTemperature)
Температура слотов:
1.3.6.1.4.1.2011.6.3.3.2.1.13 (hwSlotTemprature)
Загрузка процессоров плат:
1.3.6.1.4.1.2011.2.6.7.1.1.2.1.5 (hwMusaBoardCpuRate)
Питание:
1.3.6.1.4.1.2011.2.6.7.1.1.1.1.11 (hwMusaFramePower)
Таблица слотов:
1.3.6.1.4.1.2011.6.3.3.2 (hwSlotTable)
Статус линка GPON портов (Online — 1, Offline — 2):
1.3.6.1.4.1.2011.6.128.1.1.2.21.1.10 (hwGponDeviceOltControlStatus)
Статус vlan (up/down):
1.3.6.1.4.1.2011.5.6.1.2.1.5 (hwVlanInterfaceAdminStatus)
Статус ONU (Online — 1, Offline — 2):
.1.3.6.1.4.1.2011.6.128.1.1.2.46.1.15
.1.3.6.1.4.1.2011.6.128.1.1.2.62.1.22 (hwGponDeviceOntEthernetOnlineState)
Температура оптики ONU:
1.3.6.1.4.1.2011.6.128.1.1.2.51.1.1 (hwGponOntOpticalDdmTemperature)
Количество mac адресов подключенных к ONU:
1.3.6.1.4.1.2011.6.128.1.1.2.46.1.21 (hwGponDeviceOntControlMacCount)
Расстояние к ONU:
1.3.6.1.4.1.2011.6.128.1.1.2.46.1.20 (hwGponDeviceOntControlRanging)
Uptime OLT:
1.3.6.1.2.1.1.3 (sysUpTime)
Общее количество SNMP пакетов к OLT:
1.3.6.1.2.1.11.1 (snmpInPkts)
1.3.6.1.2.1.11.2 (snmpOutPkts)
Причина последнего отключения ONU:
1.3.6.1.4.1.2011.6.128.1.1.2.46.1.24
(hwGponDeviceOntControlLastDownCause)
The value (1) indicates that the reason is LOS(Loss of signal),
The value (2) indicates that the reason is LOSi(Loss of signal for ONUi) or LOBi (Loss of burst for ONUi),
The value (3) indicates that the reason is LOFI(Loss of frame of ONUi),
The value (4) indicates that the reason is SFI(Signal fail of ONUi),
The value (5) indicates that the reason is LOAI(Loss of acknowledge with ONUi),
The value (6) indicates that the reason is LOAMI(Loss of PLOAM for ONUi),
The value (7) indicates that the reason is deactive ONT fails,
The value (8) indicates that the reason is deactive ONT success,
The value (9) indicates that the reason is reset ONT,
The value (10) indicates that the reason is re-register ONT,
The value (11) indicates that the reason is pop up fail,
The value (13) indicates that the reason is dying-gasp,
The value (15) indicates that the reason is LOKI(Loss of key synch with ONUi),
The value (18) indicates that the reason is deactived ONT due to the ring,
The value (30) indicates that the reason is shut down ONT optical module,
The value (31) indicates that the reason is reset ONT by ONT command,
The value (32) indicates that the reason is reset ONT by ONT reset button,
The value (33) indicates that the reason is reset ONT by ONT software,
The value (34) indicates that the reason is deactived ONT due to broadcast attack,
The value (35) indicates that the reason is operator check fail,
The value (37) indicates that the reason is a rogue ONT detected by itself,
The value (-1) indicates that the query fails.
Еще несколько OID:
hwMaxMacLearn 1.3.6.1.4.1.2011.5.14.1.4.1.6
hwMacExpire 1.3.6.1.4.1.2011.5.14.1.3
hwOpticsMDWaveLength 1.3.6.1.4.1.2011.5.14.6.1.1.15
hwOpticsMDVendorName 1.3.6.1.4.1.2011.5.14.6.1.1.11
hwRingCheckAdminStatus 1.3.6.1.4.1.2011.5.21.1.7
hwVlanInterfaceID 1.3.6.1.4.1.2011.5.6.1.2.1.1
hwVlanInterfaceTable 1.3.6.1.4.1.2011.5.6.1.2
hwVlanName 1.3.6.1.4.1.2011.5.6.1.1.1.2
icmpInEchos 1.3.6.1.2.1.5.8
ipAddrEntry 1.3.6.1.2.1.4.20.1
Смотрите также мои статьи: