We will use the bandwidth capping command “config bandwidth_control“
Write it in the following order:
config bandwidth_control PORTS rx_rate no_limit/VALUE 64-1024000 tx_rate no_limit/VALUE 64-1024000
The value is set in kilobits, for example, to limit the client at port 5 of the incoming rate to 50 megabit, use the command:
config bandwidth_control 5 tx_rate 51200
View bandwidth_control parameters:
show bandwidth_control 5
An example of limiting the incoming and outgoing speeds of 1 megabit per port from 1 to 24:
config bandwidth_control 1-24 tx_rate 1024 rx_rate 1024
To remove the limit use the command:
config bandwidth_control 1-24 tx_rate no_limit rx_rate no_limit
You can configure it via the web-interface by opening the menu “QoS” – “Bandwidth Control” and you need to specify the parameters in the cells and click the “Apply “.
See also my articles:
Configuring D-Link Devices
Updating the firmware of D-Link devices