I once wrote a Zabbix template for QFX5100 and will show some of the main SNMP OIDs that I used:
Continue reading “SNMP OID for Juniper QFX”Category Archives: Hardware
Setting up Syslog on MikroTik (RouterOS)
In this article, I will show an example of how to set up sending MikroTik logs to the Syslog server.
Continue reading “Setting up Syslog on MikroTik (RouterOS)”Solution BUG: Bad page state in process kworker
Once I assembled a new access server with Accel-ppp and Intel XL710 network adapters, and after putting it into operation, I noticed that all processor cores are used evenly, and the tenth core is used almost 100%, and I also noticed messages in the logs:
Continue reading “Solution BUG: Bad page state in process kworker”SNMP OID for Netman 102 plus
Once I needed to create a template in Zabbix to monitor Netman 102 plus, I will describe which SNMP OIDs I used.
Continue reading “SNMP OID for Netman 102 plus”Alarm LASER_ALWAYS_ON from OLT 0x03000000 port EPON0/X
Once I noticed in the BDCOM P3608-2TE logs:
Continue reading “Alarm LASER_ALWAYS_ON from OLT 0x03000000 port EPON0/X”Configuring Juniper QFX5100
For example, I will configure the Juniper QFX5100-24Q-AFO switch.
Continue reading “Configuring Juniper QFX5100”linkFlapErrDisabled on Cisco Nexus
I once noticed that the port is periodically disconnected on the Cisco Nexus N3K-C3064PQ-10GX switch, there are a lot of records in the logs that the link was falling and rising, I looked at the status of the port:
Continue reading “linkFlapErrDisabled on Cisco Nexus”Huawei S3928P-EI firmware update
I will give an example of updating the firmware of the Huawei Quidway S3928P-EI switch.
Continue reading “Huawei S3928P-EI firmware update”Reboot iLO via SSH
Once I tried to open the iLO5 web interface on the HP DL380 Gen10 server and it did not open, hung on the login and password entry page, or immediately after it, iLO5 version was 2.63.
Continue reading “Reboot iLO via SSH”Configuring Juniper MX and ABillS
For example, I will configure the Juniper MX204 to work with the ABillS billing system.
Continue reading “Configuring Juniper MX and ABillS”