I’ll give you an example of viewing information about ONT (ONU) on EPON OLT BDCOM P3310C, on other models is essentially the same.
Connect to OLT and go into configuration mode:
enable
config
To view the ONU list, use the commands:
show epon onu-information
show epon active-onu
show epon inactive-onu
Example of viewing MAC addresses on a port or ONU:
show mac address-table interface EPON0/1
show mac address-table interface EPON0/1:5
show mac address-table brief
View the optical power that comes from the OLT to the ONU (ONU RX):
show epon interface ePON 0/1:5 onu ctc optical-transceiver-diagnosis
View the optical power that comes from ONU to OLT (OLT RX):
show epon optical-transceiver-diagnosis interface EPON 0/1
View ONU models and firmware versions:
show epon onu-software-version
show epon onu-software-version interface EPON 0/1
View description and status of interfaces:
show interface brief
ONU ethernet port status and viewing statistics:
show epon interface epON 0/1:1 onu port 1 state
show epon interface epON 0/1:1 onu port 1 statistics
show epon interface epON 0/1:1 onu mac address-table
Also you can see in the saved and active OLT configuration which ONUs are registered:
show configuration
show running-config
ONU reboot example:
epon reboot onu interface ePON 0/1:1
See also my article:
Configuring the BDCOM P3310 EPON
sir can we check each port information directly please tell me sir
Is there possible to us get uptime onu information ? We are using onu P1501D1 26B 554
show epon active-onu (Alivetime)