On the test I’ll take the H805GPFD board with 16 GPON ports and install it in OLT Huawei SmartAX MA5683T without shutting it down.
After inserting on the board, the RUN / ALM indicator flashed red and literally a minute later green.
Optionally, before inserting the board, you can turn on alarm output and then turn off:
alarm output all
undo alarm output all
When the board is already installed, in the configuration mode, confirm it:
board confirm 0/3
And enable ONT detection on ports:
interface gpon 0/3
port 0 ont-auto-find enable
port 1 ont-auto-find enable
port 2 ont-auto-find enable
port 3 ont-auto-find enable
port 4 ont-auto-find enable
port 5 ont-auto-find enable
port 6 ont-auto-find enable
port 7 ont-auto-find enable
port 8 ont-auto-find enable
port 9 ont-auto-find enable
port 10 ont-auto-find enable
port 11 ont-auto-find enable
port 12 ont-auto-find enable
port 13 ont-auto-find enable
port 14 ont-auto-find enable
port 15 ont-auto-find enable
quit
Let’s look at the information about the board:
display board 0/3
display cpu 0/3
Exit the configuration mode and save the current configuration:
quit
save
It is worth considering that OLT may not have a driver for the board being installed, for example, I had a case when the MA5608T had a driver for a 16-port H805GPFD board, but for an 8-port H805GPBD board, it was not there and, accordingly, the board would not work with an error:
display board 0/0
---------------------------------------
Board Name : H805GPBD
Board Status : Failed
You can view the list with the command:
display io-packetfile information
If you are using the U2000, then by clicking on the OLT, select “Synchronize NE Configuration Data”.
In the old version of U2000 R009 noticed that in the main window a question mark is displayed instead of the port of the board, in this case it is necessary to update U2000 or for example add ONT through GPON – GPON Management – GPON UNI Port tab – select port – ONU Info tab – Auto Discover ONUs.
See my video on installing H805GPFD in Huawei SmartAX MA5683T:
See also my articles:
Installing MCUD1 in Huawei MA5608
Huawei MA5608T Firmware Update
Thanks