Skip to content

IT Blog

Vyacheslav Gapon – personal blog, manuals, articles, notes, development

  • РусскийРусский

How to specify a port for snmpwalk

Posted byVyacheslav 19.12.202219.12.2022 Leave a comment on How to specify a port for snmpwalk

Once I needed to perform snmpwalk with a non-standard SNMP port, since the devices that were polled were behind the same router, so the ports were forwarded to them.

It’s simple, when executing snmpwalk, the port is specified after the IP address separated by a colon, here is an example:

snmpwalk -v2c -c ixnfo.com 192.168.5.5:555

See also my other articles about SNMP MIBs and OIDs

  • Click to share on Facebook (Opens in new window)
  • Click to share on Twitter (Opens in new window)
  • Click to share on Pinterest (Opens in new window)
  • Click to share on LinkedIn (Opens in new window)
  • Click to share on Tumblr (Opens in new window)
  • Click to share on Telegram (Opens in new window)
  • More
  • Click to share on Pocket (Opens in new window)
  • Click to share on Skype (Opens in new window)
  • Click to share on Reddit (Opens in new window)
  • Click to share on WhatsApp (Opens in new window)
  • Click to print (Opens in new window)
Posted byVyacheslav19.12.202219.12.2022Posted inLinuxTags: SNMP

Post navigation

Previous Post Previous post:
Juniper. Configuring RPF in Dynamic Profiles
Next Post Next post:
Configuring Juniper MX and ABillS

Leave a comment

Leave a Reply Cancel reply

Categories

Contacts
DONATE
About it
Privacy
Subscribe by Email (EN)
Подписаться по Email (RU)
YouTube
Instagram

При использовании материалов, активная ссылка на сайт ixnfo.com обязательна!
When using materials, an active link to ixnfo.com is required!

IT Blog © 2013-2023 Privacy Policy