How to view information about ONU on BDCOM OLT

I’ll give you an example of viewing information about ONT (ONU) on EPON OLT BDCOM P3310C, on other models is essentially the same.

Connect to OLT and go into configuration mode:

enable
config

To view the ONU list, use the commands:

show epon onu-information
show epon active-onu
show epon inactive-onu

Example of viewing MAC addresses on a port or ONU:

show mac address-table interface EPON0/1
show mac address-table interface EPON0/1:5
show mac address-table brief

View the optical power that comes from the OLT to the ONU (ONU RX):

show epon interface ePON 0/1:5 onu ctc optical-transceiver-diagnosis

View the optical power that comes from ONU to OLT (OLT RX):

show epon optical-transceiver-diagnosis interface EPON 0/1

View ONU models and firmware versions:

show epon onu-software-version
show epon onu-software-version interface EPON 0/1

View description and status of interfaces:

show interface brief

ONU ethernet port status and viewing statistics:

show epon interface epON 0/1:1 onu port 1 state
show epon interface epON 0/1:1 onu port 1 statistics
show epon interface epON 0/1:1 onu mac address-table

Also you can see in the saved and active OLT configuration which ONUs are registered:

show configuration
show running-config

ONU reboot example:

epon reboot onu interface ePON 0/1:1

See also my article:
Configuring the BDCOM P3310 EPON

Join the Conversation

3 Comments

Leave a Reply

  1. sir can we check each port information directly please tell me sir

  2. Is there possible to us get uptime onu information ? We are using onu P1501D1 26B 554