Архивы Hardware - Page 11 of 53

Juniper MX204 setup

In this article I will give an example of configuring Juniper MX204, other Juniper MX series (JunOS) can be configured in the same way.

Configuring SNMP on Juniper MX

For example, I will configure SNMP on Juniper MX204.

ONU traffic shaping on Huawei MA5600 OLT

Speed shaping on ONU is performed using dba-profile, which is specified in ont-lineprofile, in this article I will give an example of how to configure it.

Once it was necessary to link several offices in one organization into one common local network, all points were connected by different ONUs, and by default, traffic between ONUs in Smart Vlan is blocked. The setup will be done on Huawei SmartAX MA5683T, the same can be done on other Huawei MA5600 OLTs.

High CPU load on Cisco Nexus 3064

Once I discovered on the graphs a large burst of Multicast packets on one of the ports of the Cisco Nexus 3064 switch, while the CPU load increased to 30%, before that it was 12% with L2 traffic of 13 Gbit/s.

How to update BIOS U30 on HPE DL380 Gen10

For example, I will update the BIOS U30 on the HPE ProLiant DL380 Gen10 server.

Teleste Luminato Firmware Update

For example, I will update the firmware on Teleste Luminato with the installed firmware version 5.2.34.

Configuring Multicast on Eltex MES2324B

Once I needed to receive Multicast traffic from different TV providers and from different VLANs, so I had to use access-list in order to correctly transmit the igmp-report from the client to the required VLAN. If Multicast is in only one VLAN, then you can do without access-list.

BDCOM. How to determine which SFP is in the EPON port

Once it was necessary to determine which SFP modules are in EPON ports, namely C+ or C++.

Cisco Nexus 3000 Series NX-OS Fundamentals Command Reference

Size: 1.74 Mb
Format: PDF
Language: English
Last modified: July 2016

Category Archives: Hardware