If you look at the password in the Wireless – Security Profiles menu in RouterOS, then it is hidden behind the symbols and can only be changed, so I will show an example of how you can see it.
Continue reading “How to see Wi-Fi password on MikroTik”Category Archives: Hardware
Script to bind Intel NIC interrupts to processor cores
I will give the script code from Intel to bind interrupts of Intel network adapters to processor cores, and also show examples of its use:
Continue reading “Script to bind Intel NIC interrupts to processor cores”Solution channel-group command failed: port not compatible Duplex Mode
Once on Cisco Nexus I met errors of this type:
Continue reading “Solution channel-group command failed: port not compatible Duplex Mode”Juniper. How to clear Alarm Host 0 fxp0 : Ethernet Link Down
One day while configuring the Juniper MX204, I noticed that the Alarm indicator on the front panel was lit red, and looking at the list of alarms, I found the following:
Continue reading “Juniper. How to clear Alarm Host 0 fxp0 : Ethernet Link Down”Juniper. monitor traffic examples
The “monitor traffic” command allows you to view the packets or their headers that pass through the routing module, which is very useful for diagnosing various problems.
Continue reading “Juniper. monitor traffic examples”Cisco Nexus SNMP OID for Transceiver
Once I needed to monitor the optical signal level on the Cisco Nexus C3064PQ-10GX to prevent cable sagging, stretching and signal loss, because in this case the signal deteriorates gradually, usually I monitor the signal on the end equipment, but I came across an old BDCOM 3310B model in which there was no support DDM.
Continue reading “Cisco Nexus SNMP OID for Transceiver”Interface Aggregation (LAG) on Juniper MX
For example, I will configure interface aggregation on the Juniper MX204.
Continue reading “Interface Aggregation (LAG) on Juniper MX”Port isolation on HP 5800
For example, I will configure port isolation on the HPE A5800-24G-SFP switch.
Continue reading “Port isolation on HP 5800”Configuring ports on Juniper MX
In this article, I will give an example of configuring ports on a Juniper MX204.
Continue reading “Configuring ports on Juniper MX”How to reset Huawei S2326TP-EI
To reset the settings on the Huawei S2300 series switch (I will use the S2326TP-EI as an example), connect to it via the console and press the Ctrl+B or Ctrl+E key combination when turned on, after which we will get into the BOOTROM.
Continue reading “How to reset Huawei S2326TP-EI”