In the test, I’ll change the MAC address on Ubiquiti Rocket M5.
Continue reading “How to Change MAC Address on Ubiquiti (UBNT) Device”Category Archives: Hardware
Ubiquiti Rocket M5 configuration file description
For example, I’ll take the Ubiquiti Rocket M5 configuration file and describe some parameters (with other Ubiquiti equipment these parameters can be identical:
Continue reading “Ubiquiti Rocket M5 configuration file description”Configuring Huawei Quidway S2326TP-EI
The settings are essentially suitable for the entire Huawei Quidway S2300 series, but noticed that some commands may have small differences depending on the firmware version. If something does not work out, then you can look at the options for the commands by typing a question mark through a space after any command.
Continue reading “Configuring Huawei Quidway S2326TP-EI”Configuring Cisco Catalyst 2960
On the test I will configure Cisco Catalyst WS-C2960-24TT-L with firmware 12.2(25)FX
Continue reading “Configuring Cisco Catalyst 2960”LACP. Configuring Link Aggregation on D-Link Switches
Link aggregation is a technology that allows you to combine several physical channels into one logical channel, which increases the bandwidth and reliability of the channel.
Continue reading “LACP. Configuring Link Aggregation on D-Link Switches”Configuring and tuning HPE ProLiant Servers for low-latency applications
Document Name: Configuring and tuning HPE ProLiant Servers for low-latency applications
Edition: 10 (October 2017)
File size: 0.5 MB
Language: English
Configuring HP 5800
I will give an example of setting up the HP 5800 switch.
Continue reading “Configuring HP 5800”TeXet TB-116FL firmware update
Before updating the firmware, it is necessary to save all the information available in the memory, since all data will be deleted, as well as remove the memory card from the electronic book.
Continue reading “TeXet TB-116FL firmware update”Adding ONT TP-LINK TL-GP110 on Huawei SmartAX MA5683T
Suppose we went into the ONT TP-LINK TL-GP110 web interface (standard IP 192.168.1.1, admin username without password) and specified transit mode in the VLAN settings, and also disabled DHCP.
Huawei SmartAX MA5683T set up and added lineprofile/srvprofile onu profiles according to my instructions: Configuring Huawei SmartAX MA5683T
D-Link DSL-524T Firmware Update
To update the firmware of the D-Link DSL-524T modem, perform the following necessary steps:
Continue reading “D-Link DSL-524T Firmware Update”