Архивы Hardware - Page 21 of 53

Login and password for D-Link DCM-202

They once asked me the login and password for the docsis modem D-Link DCM-202 to access the web interface, since admin/admin did not fit.

Hard Reset Samsung GT-C3330

To perform a factory reset on the Samsung GT-C3330, you must enter the code on the telephone keypad

Firmware update ASUS WL-520GU

Using the example, I will update the firmware in the old ASUS WL-520GU router.

Configuring Cisco Catalyst 6509-E

Using an example, I will configure the Cisco Catalyst 6509-E with firmware 12.2 (33) SXJ7.
And so, connect to the console port, the standard speed is 9600 bps, 8N1.

Example of commands to view information about firmware and hardware:

Cisco Catalyst 6500 Management Access Restriction

To limit access to the management of the Cisco Catalyst 6500, first we make an access-list with IP addresses from which we will later allow us to connect to the device via SNMP, telnet, etc.:

Sony Ericsson E15i Xperia X8 firmware update

On the test, I will update the firmware of Sony Ericsson E15i Xperia X8 from Windows 7.

General TFTP Phonebook for IP Phones

It took one day to make a shared phone book for a large number of Grandstream IP phones.

Hard Reset Asus Nexus 7

On the test I will do a full reset on the Asus Nexus 7.
And so, let’s do the following:

How to enable Web Server on Ubiquiti via SSH

Once they asked me to remotely check the Ubiquiti NanoStation M2, in which the web interface did not open either via http or https, it was assumed that it was disabled in the settings.
The device itself responded to ping.
By SSH, too, it turned out to connect.

Ubiquiti SSH Management

To connect via SSH to Ubiquiti equipment (UBNT) from Windows, you can use the popular PuTTY utility.
From Linux, you can connect by typing the command: