On the test, I will use the D-Link DGS-3100-24TG rev.A2 switch with firmware 3.60.44 and Boot PROM v.1.0.1.05.
Continue reading “D-Link DGS-3100 firmware update”Category Archives: Hardware
TP-LINK TL-WR741ND V2 firmware upgrade from OpenWrt to factory
I updated the firmware once in the TP-LINK TL-WR741ND V2 router with OpenWrt | Kamikaze (r25068).
Standard root login without a password. The user has set some kind of password, so I had to hold the reset for 15 seconds while the router was turned on in order to reset the settings.
Configuring VLAN on Mimosa B5c
It took one time to configure several VLANs on the Mimosa B5c, the devices were already installed and the traffic passed through them without a tag in one VLAN.
Continue reading “Configuring VLAN on Mimosa B5c”Hard reset D-Link DES-1210-28/ME
On the test, I will use the D-Link DES-1210-28/ME Rev.B2 switch with firmware 6.07.B002.
Continue reading “Hard reset D-Link DES-1210-28/ME”How to copy contacts from Nokia C6 to a SIM card
Many people cannot figure out how to copy contacts from a phone to a SIM card, because the menu has the function of copying contacts from a SIM card to a phone, but on the contrary, no.
For example, I will use the phone Nokia C6-01.
Online diagnostics Cisco Catalyst 6500
In this article, I will describe the Cisco Catalyst 6500 online diagnostic commands.
Continue reading “Online diagnostics Cisco Catalyst 6500”ASUS RT-N12LX Firmware Update
For example, I will update the firmware of ASUS RT-N12LX router from version 2.0.0.35 to 2.0.0.37.
Continue reading “ASUS RT-N12LX Firmware Update”Firmware Update ASUS DSL-N10
For example, I will update the firmware of the ASUS DSL-N10 modem from version 1.0.1.2 to 1.0.5.2.
Continue reading “Firmware Update ASUS DSL-N10”Asus WL-600g Firmware Update
For example, I will update the firmware of the Asus WL-600g modem from version 1.0.3.3.A to 1.0.3.6A.
Continue reading “Asus WL-600g Firmware Update”WS-SUP720-3BXL does not start Not Applicable Unknown
Once after a power outage, on Cisco Catalyst 6509-E, instead of the main module WS-SUP720-3BXL, only the backup module was launched.
As I found out later, the memory card stopped working and, accordingly, the module could not start the firmware. At this moment on the module all the indicators glowed red.