For example, let’s take an HP ProLiant DL360p Gen8 server with BIOS version P71 07/01/2015.Continue reading “P71 BIOS Update on HP ProLiant DL360p Gen8”
I will briefly list and describe some codes:Continue reading “List and Description of DR Debug Codes for ASRock Motherboards”
To create a bootable flash drive, open the command line as administrator and enter the commands:Continue reading “Installing Windows on a GPT Disk”
I will give an example of updating the BIOS P80 on the HP ProLiant DL320e Gen8 v2 server.
Update is necessary through iLO4.
Continue reading “Update BIOS P80 on HP ProLiant DL320e Gen8 v2”
On the test, I will perform the BIOS update P70 on the HP ProLiant DL380p Gen8 server.
I will perform the update through iLO4.
At the time of this writing, the server was BIOS version 03/01/2013, and from the official site I downloaded 24/05/2019.
First you need to download the latest BIOS firmware from the official site support.hpe.com, in the search we will indicate “HPE ProLiant DL180 G6 Server”.Continue reading “BIOS update on the HP ProLiant DL180 G6 server”
On the test, I will update the BIOS on the motherboard Asus Prime B250 Plus and describe the process by points.Continue reading “BIOS update on Asus Prime B250 Plus”
Different BIOS can give an error in different ways, here are a few options:
CMOS Battery Low
CMOS battery failed
State Battery CMOS Low
CMOS Battery Has Failed
System battery is dead
CMOS Battery State Low
An error is displayed when the computer is turned on and indicates that the battery needed to store BIOS settings is empty.
The solution is to replace the battery. It is also possible to clean the contacts. To do this, you need to remove the battery from the motherboard, check if there are dust on the contacts, if there is a tester, then measure its voltage, it should usually be no lower than 3 volts.
For the test, I will perform a BIOS update on the Asus M5A78L-M LX3 motherboard.Continue reading “BIOS Update Asus M5A78L-M LX3”
Today it was necessary to go into the BIOS on the Lenovo IdeaPad 110-15IBR laptop (80T7), but when you press all the keys that are usually used to enter the BIOS, the laptop did not respond and the system continued to boot.
As it turned out, in the BIOS of this Lenovo laptop model, the HotKey Mode function is activated as standard and the functional keys are activated instead of the F1-F12 keys.
Therefore, to enter the BIOS, it is necessary to press two Fn and F2 keys simultaneously, if HotKey Mode is disabled, then simply F2.