Once I changed the battery in the iPhone 5s and at the same time decided to remove dust on the camera, for this I had to unscrew the protective plate, disconnect the display and camera cables.
And not with care, I mixed up the four bolts that held the plate, but they are of different sizes!
Below the photo, the first bolt does not magnetize, the rest are magnetized.
Repair iPhone 5s – rear camera does not work
Once I dropped a new iPhone 5s from a knee-height onto a tile, the phone was in a protective bumper, as soon as I lifted it, I noticed that the flashlight button was not active. I rebooted it, the button became active and the flashlight worked, at that moment I even shot a video, but the next day when the camera was turned on, a black screen was displayed when the camera was turned on.
For some time, I managed to switch to the front camera, but the rear one did not work.
Sometimes you could see the warning “Flash is Disabled – The iPhone needs to cool down before you can use the flash.”, But the phone was not used before and naturally could not overheat.
Sometimes also after a couple of reboots, the rear camera could start working and then again there was a black screen.
Configuring TDM410P with Asterisk
In the test, I connected a Chinese TDM410P board with four FXO ports (red) to the PCI slot of the turned off Ubuntu server.
For convenience, immediately switch to the root user:
General TFTP Phonebook for IP Phones
It took one day to make a shared phone book for a large number of Grandstream IP phones.
Continue reading “General TFTP Phonebook for IP Phones”Configuring FSK in Asterisk to determine phone numbers
To determine the number from analog lines, you need to specify in the context for each Trunk channel Dahdi:
Continue reading “Configuring FSK in Asterisk to determine phone numbers”Hard Reset Asus Nexus 7
On the test I will do a full reset on the Asus Nexus 7.
And so, let’s do the following:
How to enable Web Server on Ubiquiti via SSH
Once they asked me to remotely check the Ubiquiti NanoStation M2, in which the web interface did not open either via http or https, it was assumed that it was disabled in the settings.
The device itself responded to ping.
By SSH, too, it turned out to connect.
Using the vim text editor
vim is a free powerful text editor based on the vi text editor.
Continue reading “Using the vim text editor”Ubiquiti SSH Management
To connect via SSH to Ubiquiti equipment (UBNT) from Windows, you can use the popular PuTTY utility.
From Linux, you can connect by typing the command:
How to Change MAC Address on Ubiquiti (UBNT) Device
In the test, I’ll change the MAC address on Ubiquiti Rocket M5.
Continue reading “How to Change MAC Address on Ubiquiti (UBNT) Device”