For example, I will update the firmware of the Huawei MA5608T control board.Continue reading “Huawei MA5608T Firmware Update”
Once, on the port of one of the L3 switches of the Cisco 6509e, to which the Huawei MA5683T was connected, I saw that Multicast traffic increased very much, while the CPU load of the switch processor increased by 30%.Continue reading “How to catch flood on Huawei MA5600”
For example, I will configure the Huawei MA5608T.Continue reading “Configuring Huawei MA5608T”
The settings are essentially suitable for the entire Huawei Quidway S2300 series, but noticed that some commands may have small differences depending on the firmware version. If something does not work out, then you can look at the options for the commands by typing a question mark through a space after any command.Continue reading “Configuring Huawei Quidway S2326TP-EI”
Suppose we went into the ONT TP-LINK TL-GP110 web interface (standard IP 192.168.1.1, admin username without password) and specified transit mode in the VLAN settings, and also disabled DHCP.
Huawei SmartAX MA5683T set up and added lineprofile/srvprofile onu profiles according to my instructions: Configuring Huawei SmartAX MA5683T
Suppose we went into the ONT TP-LINK TX-6610 web interface (standard IP 192.168.0.1, admin login, admin password) and specified transparent mode in the settings.
Watch how this is done in my video:
Suppose you configured OLT as I wrote in this article Configuring the Huawei SmartAX MA5683T through the console.
Now connect via telnet or console to the Huawei SmartAX MA5683T.
After entering the login and password, we will go into configuration mode by typing the command:
In this article I will give an example of viewing and configuring logs on the Huawei SmartAX MA5683T.Continue reading “View and configure logs on the Huawei SmartAX MA5600”
On the test, I have OLT Huawei SmartAX MA5683T and EPS30-4815AF power supply.
Connect them with a regular twisted pair patchcord with RJ45 connectors.
From the OLT side, we connect the cable to the ESC port on the control board, and on the EPS30-4815AF to RS485.
After this, the OLT will be able to send commands to the EPS30-4815AF.